All You Need to Know About Submersible Pump 叶轮s and 扩散器s

All You Need to Know About Submersible Pump 叶轮s and 扩散器s

All You Need to Know About Submersible Pump 叶轮s and 扩散器s

Submersible pumps are one of the most popular types of pumps used for private well systems, 光商业, 灌溉应用. 由于他们的高需求,A.Y. McDonald carries a full line of submersibles. As a leading manufacturer in the pumps industry, we know the components that make up a submersible pump and their effect on the system – starting with the impeller and diffuser.

Making up the heart of the submersible pump, there is a lot that can be said about the impeller and diffuser. 首先, the impeller is necessary as it moves water through the pump while the diffuser directs water to the next stage. See below for additional features of each component:

叶轮

扩散器

  • 根据所需流量设计
  • Taller vanes allow more flow through impeller
  • All pumps at a given flow have the same impeller

  • Dictates total dynamic head (TDH) and flow
  • Shape and size of passages affect TDH and flow


When an impeller and diffuser are placed together, this is referred to as a stage. These “stages” are then stacked in order to achieve the desired pressure for the application. 每一级都增加压力, building on the previous stage while each additional stage requires additional power but does not increase flow.

In order to define and optimize the flow and pressure created by one stage, submersible pump engineers utilize Computational Fluid Dynamics (CFD) software. They know that impeller vane height contributes to flow (i.e. taller vanes typically equal a larger GPM), vane shape contributes to the TDH produced and amp draw on the motor, and power required per stage is based on the impeller design. 除了, impellers and 扩散器 should not have an equal number of vanes because this causes vibrations within the pump.

Both the submersible pump’s impeller and diffuser are typically made of plastic or stainless steel. A suitable material would include one that has a long life in a corrosive environment. It must be chemical resistant, stress corrosion cracking resistant, 抗冲击, and does not contaminate the water system.

There are two types of impellers: open and covered. Open impellers will clog less when moving solids and are easier to clean if clogged. However, closed impellers are generally more efficient. Small changes in the impeller have exaggerated effects on TDH and even greater effects on power required.

In order to prevent wear, the impeller needs to have a tight fit on the shaft. The impeller hub controls spacing from the diffuser. The fit between the impeller and diffuser needs to be optimized but if the diffuser fits too tight to the impeller, it limits recirculation and can’t past solids. If the diffuser is too loose, it increases recirculation and causes a loss of efficiency.

When it comes to flow and pressure of a submersible pump, there are a lot of variables to consider in relation to the design and size of the impellers and 扩散器. For more information about impellers, 扩散器, and additional components of the submersible pump, 报名参加我们的 Submersible Pump Components and Design AYU course, call our customer service department at 1-800-292-2737, or 填写一张联系表格 在我们的网站上.